I’ve been on a Tarawi Shirt-making tear over the last wee while, which I suppose is to be expected when you’re preparing a shirt pattern for release into the world!
My latest version uses the 3″/8cm check linen from A+R Fabrics in Australia. I was planning a colour-blocked version because I didn’t think I had enough fabric for a full shirt, but as I was cutting I discovered that I could squeeze the full shirt out, so long as I wasn’t too fussy about pattern placement.
This hot-off-the-machine Muna and Broad Tarawi Shirt uses the narrow-neck option which we added in for folks with proportionally small necks. My two other shirts that I’ve shared (see the purple one and the other blue one) both use the regular neckline.
With the addition of the narrow neck option, the Tarawi Shirt gives regular and narrow biceps, 4 cup-sizes and regular and narrow width necks. The hope is that this will give folks a great starting point! The size chart spans 36″-66″ (91-168cm) Bust and 41.5″-71.5″ (105-182cm) Hip, and Leila will grade the pattern up (at no extra size) if the size chart is too small to include you.
My measurements: Upper bust 43″, full bust 48″, largest measurement 56/57″, lower hip 55″. I have quite narrow shoulders, and the 5″ difference in measurements between my upper and full bust is quite misleading because that’s not my actual cup size.
Size details: I made a Size D, based on my upper bust measurements, and used the 2+ front and the narrow neck. I graded out to a little past the Size E hip to accommodate for my largest measurement and I also added 1″ to the centre of the lower-back (the piece is cut on the fold so this gave me 2″ extra through the back).
Future versions: Inspired by the lengthened versions that you can see in the hashtag #TarawiShirt, I’m thinking about a cosy mid-thigh length version from a warm fabric.